Winding MCQs with Answers PDF Download – Test 300

MCQ 1496: If the set parameter for cleaning are exceeded then yarn is:

1. cut
2. spliced
3. torn
4. both a and b

MCQ 1497: In order to check fibers without causing any eventual problems, the different points of the teeth of the controller must operate at speed:

1. within the feed and draft values
2. feed value
3. draft value
4. greater than draft value

MCQ 1498: The oiling device at the exit side features:

1. spikes
2. tube
3. nozzle
4. spraying compartment

MCQ 1499: The entry and exit sides of slivers into or from drawframe may integrate:

1. oiling devices
2. control devices
3. computerized devices
4. rotating devices

MCQ 1500: Rough untangling of tufts is done by:

1. bale plucker
2. blending chamber
3. weighing feeder
4. feeder table